Precautions for maintenance of kitchen hardware
In the daily use of the kitchen, in addition to the maintenance of the cabinet, the maintenance of the kitchen hardware is also particularly important.
Maintenance of the sink
Use neutral detergent to clean the sink. Low-carbon steel, cast iron cookware, plastic pads, wet sponges, and cleaning sheets should not be left in the sink for a long time to prevent residue from flowing into the pipe. Sprinkle a little salt on the greasy place, then wipe up and down with waste plastic wrap, and rinse with warm water several times after wiping, which can also make the sink bright as new. The cleaning of the sink should start from the basics. When you first use it, you can apply a thin layer of oil on the inner wall to isolate the surface of the sink from contact with corrosive substances as much as possible.
Maintenance of faucet
The dirt of the faucet should not be neglected. To deal with the old dirt, you can wipe it with a steel ball dipped in detergent. After cleaning with water, use a damp cloth with toothpaste or directly wipe with lemon slices to restore the faucet. bright. If there are water stains on the faucet that are difficult to remove, you can wipe a piece of fresh lemon on the faucet several times to effectively remove the water stains. If the residual water in the sink produces mineral deposits, you can use warm water and vinegar to remove it, or you can use toothpaste or talcum powder to wipe off. There are also polishing pastes on the market that specifically remove water spots and rust spots.
Hinge slide maintenance
Avoid moist air, add some lubricating oil regularly every 2-3 pieces, and wipe gently with a dry soft cloth. Drawer slide rails should avoid lateral pulling to prevent internal pulleys from wearing.
Maintenance of pull basket
Apply wax oil with strong decontamination ability to clean cotton cloth regularly, and thoroughly clean the surface. To keep the appearance of the product bright and clean, clean it regularly, do not contact with organic solvents and corrosive chemicals, such as bleach, vinegar, and use in a gas environment with the above substances, so as not to damage the surface finish and cause The product loses its luster.
